Make a Blacksmith Hammer 2017-CLASS IS FULL!

Instructors: Jim Moenck, Martin Pansch, Stephen Olivo, Derrick Phillips, Rob Murray, Bob Brown

This class will teach you the skills you need to make a hammer. With this knowledge you will then be able to expand your tool chest with other handled tools. All handled tools such as top fullers, punches and flatters start with this same process. We will begin with a piece of steel, punch the eye, shape both striking ends, heat treat and put the handle on. You will go home with your own hammer. There will be an assortment of weights to choose from so that you can make a hammer that fits you and your needs.

Safety Equipment: The normal safety equipment is required. Wear cotton clothing, leather boots above the ankle, pants that fit over the top of your boots. Eye protection and ear protection is mandatory. Gloves for protection from the heat while punching may be useful. A leather apron is encouraged for extra protection.

Tools & Equipment: Bring your favorite hammers with you to class, one for striking hot metal, one for striking punches and drifts, and a sledge for striking if you have one. All other tools will be furnished.

Lunch arrangements: We will take a break at noon for lunch. Bring your own bag lunch or eat out at one of the local establishments.

To register: This class fills up fast. Students will be accepted in the order of contact. Email is fine, but your check for $50 made out to “The Guild of Metalsmiths” is needed to reserve your spot in class. Send your check and your complete contact info to Jim Moenck at the address below:

Jim Moenck
2078 120th Ave
Dresser, WI 54009
jrmoenck@yahoo.com

Acceptance for this class is determined by postmark.